JLC Chain Hoists Hook & Lug Suspension Models
Designed for industrial duty performance. Compact in size, the JLC features a multiple disc motor brake, overload clutch, and chain end stop for safety.
Capacities & Lifts
Rated loads from 1/8, 1/4, 1/2, 1, & 2 ton. Available in standard lifts of 10, 15, and 20 feet. Other lifts available. Standard push button drop is 4-feet less than lift. CSA approved.
Available Voltages
115/230 – Single Phase; 230/460, 208, 380, 415, 575 Three Phase, 60 Hertz Standard, 50 Hertz Available
Two-Speed Hoist Models
Optional with 3 to 1 speed ratio, three-phase, single voltage only
Limit Switches
Adjustable to regulate upper and lower load travel. Brass nuts standard for improved repeatability and chain positioning.
Oil Bath Transmission
Precision machined alloy steel gears run in an oil bath for longer, quieter operation.
NEMA 3R Push Button Station
Ergonomic design fits operator’s hand for thumb or two-handed operation. 24 Volt Control for operator safety. 115 Volt control available upon request.
Frame
Compact aluminum housing for portability and ease of installation.
Accessories
Full line of accessories available, including Variable Frequency Drives.
Chain Container
Standard on lifts up to 20 ft. single chain / 10 ft. double chain.
Lifetime Warranty
Every hoist is throughly inspected and tested prior to shipment from the factory. Should any problem develop, return the complete hoist prepaid to your nearest Coffing Hoists Authorized Warranty Repair Station.
The Following are Standard Features Included on Every JLC Chain Hoist
Panel Plate
Provides easy access to controls and motor leads for changing voltages on dual-voltage motors or performing hoist maintenance. Connection wires are numbered to assist maintenance.
Five-Pocket Load Sheave
Increases chain and sheave engagement 25% over hoists with conventional four-pocket sheaves. Provides smoother lifting and reduces chain wear over four-pocket sheaves.
Multiple Disc Motor Brake
Heavy duty, direct acting design for positive load spotting and holding.
Limit Switches
Adjustable to regulate upper and lower load travel. Brass nuts standard for improved switch setting and repeatability. Stainless steel limit switch shaft standard.
Hoist Motor
Finned aluminum housing and Class F insulation for longer life. 2-speed with 3 to 1 speed ratio available.
Mechanical Overload Protection
Protects hoist, operator, and supporting structures from damaging overloads, chain jamming, and reverse phasing.
Ergonomic Push Button Station
Fits operator’s hand for thumb or two-handed operation. 24 Volt Control standard for operator safety. 115 Volt Control available upon request. NEMA 3R (weather resistant). Severe impact and chemical/corrosive atmosphere resistant.
Chain End Stop Assembly
Fits below dead end link on lifting chain for an added measure of safety.
